Honda Accord: Oil Pressure Switch Test
1 Disconnect the oil pressure switch connector (A) from the oil pressure switch (B).
2. Check for continuity between the oil pressure switch terminal and the engine (ground). There should be continuity with the engine stopped. There should be no continuity with the engine running.
Low Oil Pressure Indicator Circuit Troubleshooting (Short)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2 on page 11-3).
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehic ...
Oil Pressure Switch Replacement
1. Disconnect the oil pressure switch connector (A), then
remove the oil pressure switch (B).
2. Remove any old liquid gasket from the switch and
switch mounting hole.
3. Apply a very small am ...
See also:
Servo Body Disassembly, Inspection,
and Reassembly
1. Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
2. Inspect the valve body for scoring and damage.
3. Check shift valve D for free movement. I ...
Adjust the Front Seats.
Adjust the driver’s seat as far to the
rear as possible while allowing you to
maintain full control of the vehicle.
Have a front passenger adjust their
seat as far to the rear as possible.
...
LaneWatch TM*
Is an assistance system that allows you to check the passenger side rear
areas
displayed on the audio/information screen when the turn signal is activated to
the
passenger’s side. A camera i ...