Honda Accord: Oil Pressure Switch Replacement
1. Disconnect the oil pressure switch connector (A), then remove the oil pressure switch (B).
2. Remove any old liquid gasket from the switch and switch mounting hole.
3. Apply a very small amount of liquid gasket to the oil pressure switch threads, then install the oil pressure switch.
NOTE: Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the new oil pressure switch.
Oil Pressure Switch Test
1 Disconnect the oil pressure switch connector (A) from the oil pressure switch (B). 2. Check for continuity between the oil pressure switch terminal and the engine (ground). There should be con ...Oil Pressure Test
NOTE: If the low oil pressure warning indicator stays on with the engine running, check the engine oil level. If the oil level is correct, do the following test. 1. With the engine stopped, remov ...See also:
Idle Speed Inspection
NOTE:
- Before checking the idle speed, check these items:
- The malfunction indicator lamp (MIL) has not been
reported on, and there are no DTCs.
- Ignition timing
- Spark plug ...
Trunk Lid Torsion Bar Replacement
Special Tools Required
Torsion Bar Assembly Tool 07AAF-SNAA100
1. Remove the trunk lid torsion bars (A) from the torsion
bar center clip (B).
3. Remove the torsion bar center clip (A) from the ...
Winter Driving
Tires marked ‘‘M + S’’ or ‘‘All
Season’’ on the sidewall have an allweather
tread design suitable for
most winter driving conditions.
For the best performance in snowy
or icy ...