Honda Accord: Oil Filter Feed Pipe Replacement
1. Remove the oil filter base (see page 8-13).
2. Remove the oil filter feed pipe.
3. Install the two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe. Hold one nut with a wrench, then use a second wrench to tighten the other nut.
4. Apply new engine oil to the oil filter feed pipe threeds, then torque the oil filter feed pipe to the oil filter base to 35 Nm (3.6 kgf-m, 26 Ibfft).
5. Remove the nuts from the oil filter feed pipe, then install the oil filter base (see page 8-13).
Oil Filter Base Replacement
1. Remove the oil filter (see page 8-12).
2. Remove the exhaust pipe bracket (A), then remove
the oil filter base (B).
3. Clean the O-ring grooves and the mating surface with
the oil filter ba ...
Engine Oil Gallery Cap Replacement
1. Remove the harness bracket (A), then remove the
engine oil gallery cap (B).
2. Clean the O-ring groove and mating surface with the
engine oil gallery cap.
3. Apply new engine oil to new O-r ...
See also:
ECM/PCM Update
Special Tools Required
- Honda diagnostic system (HDS) tablet tester
- Honda Interface Module (HIM) and an iN workstation
with the latest HDS software version
- HDS pocket tester ...
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
...
Center Pocket
Pull up the lid to open each pocket. ...