Honda Accord: Oil Filter Base Replacement
1. Remove the oil filter (see page 8-12).
2. Remove the exhaust pipe bracket (A), then remove the oil filter base (B).
3. Clean the O-ring grooves and the mating surface with the oil filter base.
4. Install the oil filter base with new O-rings (C).
5. Install the oil filter (see page 8-12).
Engine Oil Filter Replacement
Special Tools Required
Oil Filter Wrench 07 AAA-PLC A100
1. Drain the engine oil (see page 8-11).
2. Remove the oil filter with the oil filter wrench.
3. Inspect the filter to make sure the ru ...
Oil Filter Feed Pipe Replacement
1. Remove the oil filter base (see page 8-13).
2. Remove the oil filter feed pipe.
3. Install the two 20 x 1.5 mm nuts (A) onto the new oil
filter feed pipe. Hold one nut with a wrench, then us ...
See also:
VSA Off Switch Test
1. Turn the ignition switch to LOCK (0).
2. Remove the driver's dashboard lower cover {see page
20-166).
3. Push out the VSA OFF switch (A) from the driver's
dashboard lower cover.
4. Check ...
Shift Lever Installation
1. Install the shift lever assembly (A).
Type A Shift Lever
Type B Shift Lever
2. Connect the shift lock solenoid connector (B) and the
park pin switch/A/T gear position indicator panel light
...
Glass Weatherstrip Replacement
1 . Remove the moonroof glass (see page 20-91).
2. Place a piece of masking tape (A) on the middle of the
front edge of the moonroof glass (B). Make sure that
the tape is on the glass only, and i ...