Honda Accord: Navigation System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Audio, Navigation, and Telematics / Navigation System
- Component Location Index
- General Troubleshooting Information
- DTC Troubleshooting Index
- Symptom Troubleshooting Index
- System Description
- Circuit Diagram
- System Diagnostic Mode
- DTC Troubleshooting
- Symptom Troubleshooting
- Forced Starting of Display
- DVD-ROM Replacement
- Navigation Unit Removal/Installation
- Navigation Display Unit Removal/Installation
- Interface Dial Removal/Installation
- Front HFL-Navigation-ANC Microphone Removal/Installation
- GPS Antenna Removal/Installation
- Voice Control Switch Test
- Voice Control Switch Replacement
Auxiliary Jack Assembly
Replacement
1. Remove the center console (see page 20-158).
2. Disconnect the 5P connector (A), and carefully pull out
the auxiliary jack assembly (B) from the center
console box.
3. Install the auxiliary ...
See also:
Symptom Troubleshooting
VSA activation indicator does not go off, and
no DTCs are stored
NOTE: If the VSA modulator was replaced prior to the
activation indicator turning on, do the VSA sensor
neutral position memorizati ...
Wheels
Clean the wheels as you would the
rest of the exterior. Wash them with
the same solution, and rinse them
thoroughly.
Aluminum alloy wheels have a
protective clear-coat that keeps the
alumin ...
ATF Cooler Cleaning
Special Tools Required
•ATF Cooler Cleaner GHTTTCF6H
-Magnetic Nonbypass Spin-On Filter GTHGNBP2*
*: Available through the Honda Tool and Equipment
Program 888-424-6857.
Before installing an ...