Honda Accord: Motor Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the headliner (see page 20-140).
2. Disconnect the connector (A), and remove the screws, then remove the motor (B).
3. Install the motor in the reverse order of removal, and note these items: - Make sure the motor connector is plugged in properly.
- Reset the moonroof control unit (see page 22-371).
- Check the motor operation.
Sunshade Replacement
1. Remove the drain channel (see page 20-94).
2. Slide the sunshade (A) until you can see both
sunshade slider spacers (B).
3. Remove the screws, then remove both sunshade
slider spacers.
4. ...
Frame and Drain Tube Replacement
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-23),
4-door (see page 24-21) and the precautions and
procedures (see page 24-25) before doing repair ...
See also:
A/C Condenser Fan High Speed Circuit
Troubleshooting
ECM/PCM CONNECTOR A (49P)
Terminal side of female terminals
Is there battery voltage?
YES-Go to step 6.
NO-Repair an open in the wire between the
under-hood fuse/relay box and the ECM/PCM. If ...
Defaulting All the Settings
Reset all the menu and customized settings as the factory defaults.
1. Press the SETTINGS button.
1. Press and hold the DISP button.
2. Rotate to select System
Settings, then
press .
...
Self-diagnostic Function
NOTE: Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode
A (see page 22-134).
The gauge control module has a self-diagnostic functio ...