Control Unit Input Test

NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). Driver's MICU 1. Turn the ignition switch to LOCK (0), ...

Component Location Index

...

See also:

Rear License Plate Light Bulbs
When replacing, use the following bulbs. 1. Remove the license plate light assembly by pushing the left edge of the lens toward the right and pulling the assembly out. 2. Remove the lens b ...

Piston Installation
If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

Recirculation Control Motor Circuit Troubleshooting
908-09 models 4-door with A/T and '10 model with AT 1. Check the No. 16 (7.5 A) fuse in the driver's under-dash fuse/ relay box. Is the fuse OK? YES-Go to step 2. NO-Replace the fuse, and re ...