Honda Accord: Mode Control Motor Replacement
1. Remove the blower unit (see page 21-65).
2. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit.
3. Install the motor in the reverse order of removal.
Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
Mode Control Motor Test
'08-09 models with A/T and '10 model
with A/T
NOTE; Before testing the motor, check for HVAC DTCs
(see page 21-9).
1. Disconnect the 7P connector from the mode control
motor.
Incorrectly app ...
Recirculation Control Motor Test
'08-09 models 4-door with A/T and "10 model
with A/T
NOTE: Before testing the motor, check for HVAC DTCs
(see page 21-9).
1. Disconnect the 7P connector from the recirculation
control moto ...
See also:
Front Inner Fender Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the body.
- When prying with a flat-tip screwdriver, wrap it with protective tape to
prevent damage.
1. Remove the f ...
Horn Switch Test
NOTE: Check for a blown No. 10 (20 A) fuse in the
under-hood fuse/relay box. If it is blown, check for a
faulty horn relay.
1. Turn the steering wheel 180 degrees from the center
position and re ...
Carrying Cargo
Your vehicle has several convenient
storage areas:
Glove box
Door and seat-back pockets
Roof-rack (if installed)
Center pockets
Console compartment
Trunk, including the rear seat
when fold ...