Honda Accord: Mirror Housing Cover Replacement
1. Remove the mirror holder (see page 20-63).
2. From the mirror holder opening, release the hooks (A) of the mirror housing cover (B).
3. Release the hooks (A), then remove the mirror housing cover (B).
4. Install the mirror housing cover in the reverse order of removal, and push the hooks into place securely.
Mirror Holder Replacement
NOTE: - Put on gloves to protect your hands. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Carefully push on the top edge of the mirror holder ( ...Rearview Mirror Replacement
Without Automatic Dimming Mirror 1. Turn the rearview mirror base (A) 90 В°. 2. Slide the rearview mirror base (A) down toward the bottom of the windshield to detach it from the spring (B) in ...See also:
Door Locks
To lock both doors, push the front of
the master door lock switch on
either door, pull the lock tab
rearward on the driver’s door, or use
the key on the outside lock on the
driver’s do ...
DTC Troubleshooting
DTC P0101: MAF Sensor Circuit
Range/Performance Problem
NOTE:
- Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see ...
Braking System Design
The hydraulic system that operates
the brakes has two separate circuits.
Each circuit works diagonally across
the vehicle (the left-front brake is
connected with the right-rear brake,
etc.). ...