Honda Accord: MICU Input Test - Turn Signal/Hazard Warning Lights - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: MICU Input Test

NOTE: • Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134).

• Before testing, make sure the No. 5 (7.5 A) fuse in the driver's under-dash fuse/relay box is OK.

Driver's MSCU

1. Turn the ignition switch to LOCK (0), and remove the driver's dashboard lower cover (see page 20-166).

2. Disconnect driver's under-dash fuse/relay box connectors D, F, N, P, Q, and R.

NOTE: All connector views are wire side of female terminals.


3. Inspect the connector and socket terminals to be sure they are all making


3. Inspect the connector and socket terminals to be sure they are all making good contact.

• If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.

• If the terminals look OK, go to step 4 .

4. With the connectors still disconnected, do these input tests at the appropriate following connector.

• If any test indicates a problem, find and correct the cause, then recheck the system, • If all the input tests prove OK, go to step 5.

5. Reconnect the connectors to the driver's under-dash fuse/relay box, and


5. Reconnect the connectors to the driver's under-dash fuse/relay box, and make these input tests at the connectors.

• If any test indicates a problem, find and correct the cause, then recheck the system.

• If all the input tests prove OK, the driver's MICU must be faulty; replace the driver's under-dash fuse/relay box: - USA models (see page 22-86) - Canada models (see page 22-87)

Hazard Warning Switch


    DTC Troubleshooting
    DTC B1280: Turn Signal Switch Circuit Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. ...

    Hazard Warning Switch Test/Replacement
    1. Remove these items: • Center vent for w i t h navigation system (see page 20-178) • Audio unit for without navigation system (see page 23-115) 2. Remove the hazard warning switch (A) ...

    See also:

    Immobilizer Key Registration
    NOTE: • The HDS is required for registration of the immobilizer keys. • Programming the immobilizer also programs the keyless transmitter. • Check for aftermarket electrical eq ...

    Ignition Key Light Test
    1. Remove the steering column upper and lower covers (see page 20-181). 2. Disconnect the 6P connector (A). 3. The LED should come on when power is connected to terminal No. 6 and ground is co ...

    General Troubleshooting Information
    Intermittent Failures The term Intermittent failure means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poo ...