Honda Accord: MAP Sensor Replacement
1. Disconnect the MAP sensor connector (A).
2. Remove the MAP sensor (B).
3. Install the parts in the reverse order of removal with a new O-ring (C).
CKP Sensor Replacement
1. Raise the vehicle on a lift.
NOTE: Make sure the vehicle is level, because engine
oil will drip out when you remove the sensor.
2. Remove the CKP sensor cover (A).
3. Disconnect the CKP s ...
MAF Sensor/IAT Sensor Replacement
1. Disconnect the MAF sensor/IAT sensor connector (A).
2. Remove the screws (B).
3. Remove the MAF sensor/IAT sensor (C).
4. Install the parts in the reverse order of removal with a
new O-ri ...
See also:
Rear Seat Access
Driver’s Side
On all V6 models and 4-cylinder EX-L
model
To get into the rear seat on the
driver’s side, open the door and pull
the release lever up on the side of
the seat-back. The s ...
Synchronized Mode
You can set the temperature synchronously for the driver side and the
passenger
side in synchronized mode.
1. Press the SYNC button.
- The system will switch to the synchronized mode.
...
Crankshaft Main Bearing Replacement
Main Bearing Clearance Inspection
1. To check the main bearing-to-journal oil clearance,
remove the lower block and the bearing halves (see
page 7-14).
2. Clean each main journal and the bearing ...