Clutch (cont'd)

Manual Transmission and M/T Differential (cont'd)

See also:

Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed. 1. Measure the cylinder bores (see page 7-17). If the engine block is to be reused, hone the cylinders, and remeasure the bores. 2. Re ...

B-CAN System Diagnosis Test Mode 1 and Test Mode 2 (without the HDS)
Special Tools Required MFCS (MCIC) Service Connector 07WAZ-00101 OA Test Mode 1 Check the ECM/PCM for DTCs and troubleshoot ECM/PCM (see p a g e 11-3) or F-CAN loss o f communication errors first ...

Selector Control Shaft Oil Seal Replacement
Special Tools Required -Driver Handle, 15 x 135L 07749-0010000 -Oil Seal Driver Attachment 07947-ZV00100 1. Remove the oil seal (A) from the torque converter housing (B). 2. Install a new oil s ...