Honda Accord: Manual Transmission
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / Manual Transmission
- Special Tools
- Component Location Index
- Symptom Troubleshooting Index
- Transmission Fluid Inspection and Replacement
- Back-up Light Switch Test
- Transmission Removal
- Transmission Installation
- Transmission Disassembly
- Reverse Shift Fork Clearance Inspection
- Change Lever Clearance Inspection
- Change Lever Assembly Disassembly/Reassembly
- Shift Fork Clearance Inspection
- Shift Fork Disassembly/Reassembly
- Mainshaft Assembly Clearance Inspection
- Mainshaft Disassembly
- Mainshaft Inspection
- Mainshaft Reassembly
- Countershaft Assembly Clearance Inspection
- Countershaft Disassembly
- Countershaft Inspection
- Countershaft Reassembly
- Synchro Sleeve and Hub Inspection and Reassembly
- Synchro Ring and Gear Inspection
- Mainshaft Bearing and Oil Seal Replacement
- Countershaft Bearing Replacement
- Mainshaft Thrust Clearance Adjustment
- Transmission Reassembly
- Gearshift Mechanism Replacement
- Shift Lever Housing Replacement
Clutch Replacement
Special Tools Required
- Clutch Alignment Disc 07JAF-PM7011A
- Ring Gear Holder 07LAB-PV00100 or 07924-PD20003
- Clutch Alignment Tool Set 07PAF-0020000
- Clutch Alignment ...
Special Tools
* : Part of Mainshaft Inspection Tool Set, 07GAJ-PG20102.
* * : Must be used with commercially available 3/8"-16 UNF Slide Hammer. *
...
See also:
ECON Button
The ECON button turns the ECON mode on and off.
The ECON mode helps you improve your fuel economy by adjusting the
performance of the engine, transmission, heating and cooling system/climate
co ...
Radio Theft Protection
Your vehicle’s audio system may
disable itself if it is disconnected
from electrical power for any reason.
To make it work again, you must
enter a specific five-digit code with
the preset b ...
MIL Circuit Troubleshooting
1. Turn the ignition switch to ON (II).
2. Do the gauge self-diagnostic function (see page
22-332).
Does the MIL indicator flash?
YES-Go to step 3.
NO-Substitute a known-good gauge control ...