Honda Accord: Maintain a Proper Sitting Position - Protecting Adults and Teens - Driver and Passenger Safety - Honda Accord 2008-2012 Owner's ManualHonda Accord: Maintain a Proper Sitting Position

After all occupants have adjusted their seats and head restraints, and put on their seat belts, it is very important that they continue to sit upright, well back in their seats, with their feet on the floor, until the vehicle is safely parked and the engine is off.

Sitting improperly can increase the chance of injury during a crash. For example, if an occupant slouches, lies down, turns sideways, sits forward, leans forward or sideways, or puts one or both feet up, the chance of injury during a crash is greatly increased.

In addition, an occupant who is out of position in the front seat can be seriously or fatally injured in a crash by striking interior parts of the vehicle or being struck by an inflating front airbag.

Sitting improperly or out of

Sitting improperly or out of position can result in serious injury or death in a crash.

Always sit upright, well back in the seat, with your feet on the floor.

    Fasten and Position the Seat Belts
    Insert the latch plate into the buckle, then tug on the belt to make sure the belt is securely latched. Check that the belt is not twisted, because a twisted belt can cause serious injuries ...

    Advice for Pregnant Women
    If you are pregnant, the best way to protect yourself and your unborn child when driving or riding in a vehicle is to always wear a seat belt, and keep the lap part of the belt as low as p ...

    See also:

    Control Unit Input Test
    NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). Driver's MICU 1. Turn the ignition switch to LOCK (0), ...

    Front Door Weatherstrip Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the door. - Take care not to damage the front upper corner clip (black) (4-door) and the rear upper corner clips (black) ...

    Connector Index
    Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter "C" for connectors, " G " for ground te ...