Honda Accord: Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
- Oil Seal Driver, 65 07JAD-PL90100
- Adjustable Bearing Puller, 20-”40 mm 07736-A01000B
- Bearing Driver Attachment, 42 x 47 07746-0010300
- Driver Handle, 15 x 135L 07749-0010000
- Slide Hammer 3/8"-16 UNF, commercially available
1. Remove the ball bearing (A) from the clutch housing (B) using the 20-”40 mm adjustable bearing puller (C) and a commercially available 3/8"-16 UNF slide hammer (D).
2. Remove the oil seal (A) from the clutch housing. Be careful not to damage the clutch housing when removing the oil seal.
3. Drive in a new oil seal from the transmission side using the 15 x 135L driver handle (A) and the 42 x 47 bearing driver attachment (B).
4. Drive in a new ball bearing (A) from the transmission side using the 65 oil seal driver (B).
Synchro Ring and Gear Inspection
1. Inspect the synchro rings for scoring, cracks, and
damage (A).
Example of synchro ring teeth
2. Inspect the inside of each synchro ring (B) for wear.
Inspect the ...
Countershaft Bearing Replacement
Special Tools Required
- Oil Seal Driver, 65 07JAD-PL90100
- Adjustable Bearing Puller, 20-”40 mm 07736-A01000B
- Slide Hammer 3/8"-16 UNF, commercially available
1. Remove the bearing ...
See also:
Control Unit Input
Test/Replacement
1. Remove the driver's dashboard lower cover (see page 20-166).
2. Remove the screws, then disconnect the 28P connector (A) from the
HandsFreeLink control unit (B).
3. Inspect the connector an ...
System Description
Delay Orifice Mechanism
Function
The delay orifice mechanism improves clutch operation by delaying the slave
cylinder release speed when the clutch
pedal is suddenly released. The delay orifice m ...
Center Console Removal/Installation
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the front seat, the dashboard,
or the related parts.
1 . Remove these items:
- Center console panel (see page 20-157)
...