Honda Accord: MAF Sensor/IAT Sensor Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: MAF Sensor/IAT Sensor Replacement

1. Disconnect the MAF sensor/IAT sensor connector (A).

2. Remove the screws (B).


2. Remove the screws (B).

3. Remove the MAF sensor/IAT sensor (C).

4. Install the parts in the reverse order of removal with a new O-ring (D).

    MAP Sensor Replacement
    1. Disconnect the MAP sensor connector (A). 2. Remove the MAP sensor (B). 3. Install the parts in the reverse order of removal with a new O-ring (C). ...

    ECT Sensor 1 Replacement
    1. Drain the engine coolant (see page 10-6). 2. Disconnect the ECT sensor 1 connector (A). 3. Remove ECT sensor 1 (B). 4. Install the parts in the reverse order of removal with a new O-ring ...

    See also:

    Checking Tires
    To safely operate your vehicle, your tires must be of the proper type and size, in good condition with adequate tread, and properly inflated. • Inflation guidelines Properly inflated tires pro ...

    Drive Belt Removal/Installation
    Special Tools Required Belt Tension Release Tool Snap-on YA9317 or equivalent, commercially available 1. Move the auto-tensioner (A) with the belt tension release tool (B) in the direction of the ...

    Park Lever Stop Inspection and Adjustment
    1. Set the park lever in the P position. 2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard: 57.7-58.7 mm (2.27-2.31 in) 3. If the measurem ...