Honda Accord: Lubricants a n d Fluids
For the details of the lubrication points and the type of lubricants to be applied, refer to the illustrated index and the various work procedures (such as Assembly/Reassembly, Replacement Overhaul, Installation, etc.) contained in each section.
NOTE: * Lubricate the following areas using the recommended lubricants and fluids.
- In corrosive areas, more frequent lubrication is necessary.
O A J E
Maintenance
...
See also:
Mainshaft Assembly Clearance Inspection
1. Support the bearing Inner race with an appropriate
sized socket ( A ) , and push down on the mainshaft ( B ) .
2. Measure the clearance between 2nd gear (C) and 3rd
gear (D) with a feeler gaug ...
Oil Check
Wait a few minutes after turning the
engine off before you check the oil.
1. Remove the dipstick (orange
handle/loop).
2. Wipe off the dipstick with a clean
cloth or paper towel.
3. Inser ...
System Diagnostic Mode
Start-up procedure and Diagnostic IVieny
There are two ways t o enter the diagnostic mode:
Method 1 :
Start the vehicle. When the globe screen appears,
connect the SCS service connector (see page ...