Honda Accord: Low Oil Pressure Indicator Circuit Troubleshooting (Short) - Engine Lubrication - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Low Oil Pressure Indicator Circuit Troubleshooting (Short)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3).

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it does not communicate, troubleshoot the DLC circuit (see page 11-181).

4. Check for DTCs (see page 11-3). If a DTC is present, diagnose, and repair the cause before continuing with this test.

5. Start the engine, and check the OIL PRESSURE SWITCH in the PGM-FI DATA LIST with the HDS.

Is OFF indicated? .

YES

-Reolace the gauge control module (see page 22-351 ).

NO

-Go to step 6.

6. Turn the ignition switch to LOCK (0).

7. Disconnect the oil pressure switch connector.

8. Start the engine, and check the OIL PRESSURE SWITCH in the PGM-FI DATA LIST with the HDS.

Is OFF indicated? - YES-Turn the ignition switch to LOCK (0), then go to step 9.

NO-Turn the ignition switch to LOCK (0), then go to step 10.

9. Check the oil pressure switch (see page 8-9).

Is the oil pressure switch OK? YES-Do the oil pressure test (see page 8-10).

NO-Replace the oil pressure switch (see page 8-9).

10. Turn the ignition switch to ON (II), and jump the SCS line with the HDS, then turn the ignition switch to LOCK (0).

NOTE: This step must be done to protect the ECM/PCM from damage.

11. Disconnect ECM/PCM connector B (49P).

12. Check for continuity between the oil pressure switch connector and body ground.

OIL PRESSURE SWITCH CONNECTOR '

Wire side of female terminal


Wire side of female terminal

Is there continuity? YES

-Repair short to ground in the wire between the oil pressure switch and ECM/PCM connector terminal B7.

NO

-Update the ECM/PCM if it does not have the latest software (see page 11-203), or substitute a known-good ECM/PCM (see page 11-7), then recheck.

If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM (see page 11 -204).

    Low Oil Pressure Indicator Circuit Troubleshooting (Open)
    1 Connect the Honda Diagnostic System (HDS) to the data Jink connector (DIG) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (ll). 3. Make sure the HDS communicates with the vehicl ...

    Oil Pressure Switch Test
    1 Disconnect the oil pressure switch connector (A) from the oil pressure switch (B). 2. Check for continuity between the oil pressure switch terminal and the engine (ground). There should be con ...

    See also:

    Symptom Troubleshooting Information
    General Check Before Troubleshooting Before troubleshooting the immobilizer system, check the following general items and solve any if applicable: • The battery is low; charge the battery ful ...

    Devices that Emit Radio Waves
    The following products and systems on your vehicle emit radio waves when in operation. Each of the above complies with the appropriate requirements or the required standards of FCC (Federal Com ...

    Radio Theft Protection
    Your vehicle’s audio system may disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific five-digit code with the preset b ...