Honda Accord: Low Fuel Indicator Test - Fuel Supply System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Low Fuel Indicator Test

1. Do the gauge self-diagnostic test (see page 22-332).

- If the low fuel indicator flashes, go to step 2.

- If the low fuel indicator does not flash, replace the gauge control module (see page 22-351).

2. Check for body electrical system DTCs.

- If any DTCs are indicated, do the indicated DTCs troubleshooting.

- If no DTCs are indicated, go to step 3.

3. Do the fuel gauge sending unit test (see page 11-328).

    Fuel Gauge Sending Unit Test
    NOTE: For the fuel gauge system circuit diagram, refer to the Gauges Circuit Diagram (see page 22-336). 1. Check the No. 5 METER (7.5 A) fuse in the driver's under-dash fuse/relay box before test ...

    Intake Air System
    ...

    See also:

    Door Key Cylinder Switch Test
    1. Remove the driver's door panel (see page 20-17). 2. Disconnect the 10P connector (A) from the door lock actuator (key cylinder switch) (B). 3. Check for continuity between the terminals. ...

     Front Seat Belt Replacement
    Front Seat Belt - 2-door SRS components are located in this area. Review the SRS component locations (see page 24-23) and the precautions and procedures (see page 24-25) before doing repairs or se ...

    If the Low Tire Pressure/TPMS IndicatorComes On or Blinks
    • Reasons for the indicator to come on or blink A tire pressure is significantly low, or the TPMS has not been calibrated. If there is a problem with the TPMS or the compact spare tire is inst ...