Honda Accord: License Plate Light Replacement
4-door
1. Poll the license plate light assembly out, and disconnect the 2P connector (A) from the license plate light.
License Plate Light: 5W
2. Separate the lens (B) and housing (C), then remove the bulb.
3. Install the light in the reverse order of removal
2-door
1. Remove the license plate light (A), and disconnect the 2P connector (B) from the license plate light.
License Plate Light: 5 W
2. Separate the lens (C) and housing (D), then remove the bulb.
3. Install the light in the reverse order of removal.
Taillight Replacement
4-door
1 Remove the rear bumper (see page 20-260).
2. Remove the trunk side trim panel (see page 20-132).
3. Disconnect the connectors (A) from the taillights (B).
4 . Turn the bulb sockets ...
High Mount Brake Light Replacement
1. Open the trunk lid.
2. Disconnect the 2P connector (A) from the high mount
brake light.
High Mount Brake Light: 21 W
3. Turn the bulb socket (B) 45 В° counterclockwise to
remove the bulb ...
See also:
Symptom Troubleshooting
Hard Steering
NOTE:
-Compare to a known-good vehicle that is the same
trim level.
-Check for suspension damage.
m Check the steering alignment.
-Check the tire condition and pressure.
1 ...
Clutch Disassembly
Special Tools Required
Clutch Spring Compressor Set 07LAE-PX40000
1. Remove the snap ring using a screwdriver.
2. Remove the clutch end-plate (A), the clutch discs (B)
(5), the clutch wave-plate ...
ECT Sensor 1 Replacement
1. Drain the engine coolant (see page 10-6).
2. Disconnect the ECT sensor 1 connector (A).
3. Remove ECT sensor 1 (B).
4. Install the parts in the reverse order of removal with a
new O-ring ...