Honda Accord: Keyless/Power Door
Locks/Security System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Keyless/Power Door
Locks/Security System
- Component Location Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Symptom Troubleshooting Index
- Symptom Troubleshooting
- Control Unit Input Test
- Door Lock Actuator Test
- Door Lock Knob Switch Test
- Door Key Cylinder Switch Test
- Security Hood Switch Test
- Trunk Lid Release Actuator Test
- Transmitter Test
- Tripped Sensor History
MICU input Test
NOTE: Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode
A (see page 22-134).
Driver's MICU
1. Turn the ignition switch to LOCK (0), ...
Component Location Index
4-door
4-door
2-door
2-door
...
See also:
In-car Temperature Sensor
Replacement
1. Remove the driver's inner dashboard trim (see page
20-167).
2. Disconnect the connector (A), and remove the in-car
temperature sensor (B) from the air hose (C).
3. Install the sensor in the ...
Stabilizer Link Removal/Installation
1. Raise and support the vehicle (see page 1 -13).
2. Remove the front wheel.
3. Remove the self-locking nut (A) and the flange nut (B)
while holding the respective joint pin (C) with a hex
wr ...
Countershaft Bearing Replacement
Special Tools Required
- Oil Seal Driver, 65 07JAD-PL90100
- Adjustable Bearing Puller, 20-”40 mm 07736-A01000B
- Slide Hammer 3/8"-16 UNF, commercially available
1. Remove the bearing ...