Honda Accord: Intermediate Shaft Disassembly
Special Tools Required
•Half Shaft Base 07NAF-SR30101
-Oil Seal Driver, 44.5 mm 07947-SB00100
1. Remove the heat shield (A).
3. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using the half shaft base (C) and a press. Be careful not to damage the bearing support ring (D) on the intermediate shaft during disassembly.
4. Remove the internal snap ring (A) from the bearing support (B).
5. Press the intermediate shaft bearing (A) out of the bearing support (B) using the 44.5 mm oil seal driver (CL the half shaft base (D), and the press.
Intermediate Shaft Removal
1. Drain the transmission fluid. Reinstall the drain plug
using a new sealing washer:
-Manual transmission (see page 13-5)
-Automatic transmission (see page 14-192)
2. Remove the right driveshaft ...
Intermediate Shaft Reassembly
Exploded View
Special Tools Required
-Oil Seal Driver 07GAD-PH70201
-Half Shaft Base 07NAF-SR30101
-Attachment 52 x 55 mm 07746-0010400
-Attachment 35 mm I.D. 07746-0030400
-Driver Handle, 15 ...
See also:
Driver's Outer Dashboard Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or the related
pa ...
Brake/Clutch Fluid
Use the same fluid for both the brakes and clutch.
• Checking the Brake Fluid
The fluid level should be between the MIN
and MAX marks on the side of the reservoir.
NOTICE
Brake fluid marke ...
Road Test
1. Apply the parking brake, and block both rear wheels.
Start the engine, and warm it up to normal operating
temperature (the radiator fan comes on).
2. Shift to D while pressing the brake peda ...