Low Fuel Indicator Test

1. Do the gauge self-diagnostic test (see page 22-332). - If the low fuel indicator flashes, go to step 2. - If the low fuel indicator does not flash, replace the gauge control module (see page ...

Component Location Index

...

See also:

F-CAN Circuit Troubleshooting
1. Turn the ignition switch to LOCK (0). 2. Jump the SCS line with the HDS. 3. Disconnect ECM/PCM connector A (49P). 4. Measure the resistance between ECM/PCM connector terminals A3 and A4. ...

Safety Labels
Label Locations These labels are in the locations shown. They warn you of potential hazards that can cause serious injury or death. Read these labels carefully. If a label comes off or becomes h ...

Checking the Battery
Check the battery condition monthly. Look at the test indicator window and check the terminals for corrosion. The battery condition is being monitored by the sensor on the negative terminal. ...