Honda Accord: Intake Air Resonator
Removal / Installation
1. Do the battery removal procedure (see page 22-92).
2. Remove the air cleaner (see page 11-332).
3. Remove the battery base (A)
4. Remove the front grille cover.
- 2-door (see page 20-274)
- 4-door (see page 20-274)
5. Remove the water separator (A) and the intake duct (B).
6. Remove the front bumper (see page 20-255).
7. Remove the intake air resonator (A).
8. Install the parts in the reverse order of removal.
9. Do the battery installation procedure (see page 22-92).
Air Cleaner Element
Inspection / Replacement
1. Open the air cleaner housing cover (A).
2. Remove the air cleaner element (B) from the air
cleaner housing (C).
3. Check the air cleaner element for damage or clogging.
If it is damaged o ...
Throttle Body Removal/Installation
Do not insert your fingers into the installed throttle body when you turn
the ignition switch to ON (II) or while the
ignition switch is in ON (II). If you do, you will seriously injure your finger ...
See also:
Courtesy Light Replacement
1 Carefully pry off the lens (A) with a small screwdriver.
Courtesy Light: 2 CP
2. Remove the bulb (B) from the socket.
3. Install the light in the reverse order of removal. ...
Engine Oil Gallery Cap Replacement
1. Remove the harness bracket (A), then remove the
engine oil gallery cap (B).
2. Clean the O-ring groove and mating surface with the
engine oil gallery cap.
3. Apply new engine oil to new O-r ...
Changing the Set Speed
You can increase the set cruising
speed in any of these ways:
Press and hold the RES/ACCEL
button. When you reach the
desired cruising speed, release the
button.
Push on the accelerator peda ...