Safety Labels

Label Locations These labels are in the locations shown. They warn you of potential hazards that can cause serious injury or death. Read these labels carefully. If a label comes off or becomes h ...

Indicators

...

See also:

Key Interlock Solenoid Test
NOTE: SRS components are located in this area. Review the SRS component locations for 4-door (see page 24-21),for 2-door (see page 24-23), and the precautions and procedures (see page 24-25) before ...

DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Turn the ignition switch to LOCK (0), and then to ON (II). 2. Do the self-diagnostic function with the HVAC control unit (see pa ...

Compass Zone Selection
In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this: ...