Honda Accord: Installing a Child Seat with a Lap/Shoulder Belt - Installing a Child Seat - Driver and Passenger Safety - Honda Accord 2008-2012 Owner's ManualHonda Accord: Installing a Child Seat with a Lap/Shoulder Belt

When not using the LATCH system, all child seats must be secured to the vehicle with the lap part of a lap/ shoulder belt.

In addition, the lap/shoulder belts in all seating positions except the driver’s have a lockable retractor that must be activated to secure a child seat.

1. With the child seat in the desired

1. With the child seat in the desired seating position, route the belt through the child seat according to the seat maker’s instructions, then insert the latch plate into the buckle and remove any slack from the lap portion of the belt.

2. To activate the lockable retractor,

2. To activate the lockable retractor, slowly pull the shoulder part of the belt all the way out until it stops, then let the belt feed back into the retractor.

3. After the belt has retracted, tug on it. If the belt is locked, you will not be able to pull it out. If you can pull the belt out, it is not locked, and you will need to repeat these steps.

4. After confirming that the belt is

4. After confirming that the belt is locked, grab the shoulder part of the belt near the buckle, and pull up to remove any slack from the lap part of the belt. Remember, if the lap part of the belt is not tight, the child seat will not be secure.

To remove slack, it may help to put weight on the child seat, or push on the back of the seat while pulling up on the belt.

5. Push and pull the child seat

5. Push and pull the child seat forward and from side-to-side to verify that it is secure enough to stay upright during normal driving maneuvers. If the child seat is not secure, unlatch the belt, allow it to retract fully, then repeat these steps.

To deactivate the lockable retractor and remove a child seat, unlatch the buckle, unroute the seat belt, and let the belt fully retract.

    Installing a Child Seat with LATCH
    Your vehicle is equipped with LATCH (Lower Anchors and Tethers for CHildren) at the outer rear seats. The lower anchors are located between the seat-back and seat bottom, and are to be used ...

    Installing a Child Seat with a Tether
    A child seat with a tether can be installed in any seating position in the back seat, using one of the anchorage points shown above. Since a tether can provide additional security to the la ...

    See also:

    HFL Menus
    The power mode must be in ACCESSORY or ON to use HFL. • Phone Settings screen 1. Press the SETTINGS button. 2. Rotate to select Phone Settings, then press . To use HFL, you must first pa ...

    Seat Belt Inspection
    Regularly check the condition of your seat belts as follows: • Pull each belt out fully, and look for frays, cuts, burns, and wear. • Check that the latches work smoothly and the belts retract ...

    Trunk Lid Weatherstrip Replacement
    NOTE: 4-door Is shown; 2-door Is similar. 1. Remove the trunk lid weatherstrip (A) by pulling it off. 2. Locate the painted alignment mark (B or C) on the trunk lid weatherstrip. Align the pain ...