Honda Accord: Input Shaft (Mainshaft) Speed Sensor
Replacement
1. Remove the nut securing the under-hood fuse/relay box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner housing.
3. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
4. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor in the transmission housing.
5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
6. Install the intake air duct and the air cleaner housing.
7. Install the under-hood fuse/relay box.
A/T Clutch Pressure Control Solenoid
Valve B and C Replacement
1. Do the battery removal procedure (see page 22-92).
2. Remove the battery base (see step 8 on page 5-3).
3. Disconnect the A/T clutch pressure control solenoid
valves B and C connectors.
4 ...
Output Shaft (Countershaft) Speed
Sensor Replacement
1. Remove the nut securing the under-hood fuse/relay
box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner
housing.
3. Disconnect the output shaft (countershaft) ...
See also:
Steering Gearbox Overhaul
Exploded View
Special Tools Required
-Cylinder End Seal Remover Attachment
07TAF-SZ50100
-Valve Seal Ring Sizing Tool 07NAG-SR3090A
-Sleeve Seal Guide, 35.9 x 37
07YAG-S2X0100
-Sizing Tool, ...
Yaw Rate-Lateral Acceleration Sensor Replacement
NOTE:
- Do not damage or drop the sensor as It Is sensitive.
- Do not use power tools when replacing the
sensor.
1. Turn the ignition switch to LOCK (0).
2. Remove the center console (see ...
Maximum Load Limit
The maximum load for your vehicle is 850 lbs (385 kg).
See Tire and Loading Information label attached to the driver's doorjamb.
This figure includes the total weight of all occupants, cargo, an ...