Honda Accord: Immobilizer System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Body Electrical / Immobilizer System
- Component Location Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Symptom Troubleshooting Information
- Symptom Troubleshooting Index
- Symptom Troubleshooting
- System Check
- Status Log
- Immobilizer-Keyless Control Unit Input Test
- Immobilizer Key Registration
- Immobilizer-Keyless Control Unit Replacement
Defogger Wire Repair
NOTE: To make an effective repair, the broken section
must be no longer than 1.0 in (25 mm).
1. Lightly rub the area around the broken section (A)
with fine steel wool, then clean it with isoprop ...
See also:
Receiver/Dryer Desiccant
Replacement
NOTE: Install the receiver/dryer as quickly as possible to
prevent the system from absorbing moisture from the
air.
1. Remove the A/C condenser (see page 21 -77).
2. Remove the bolts from the ...
A/C Pressure Switch Circuit
Troubleshooting
NOTE:
• Do not use this troubleshooting procedure if any of the
following items are operative: The condenser fan, the
radiator fan, or the A/C compressor, or if the heater is
inoperative. Ref ...
If the Malfunction Indicator LampComes On or Blinks
• Reasons for the indicator lamp to come on or blink
• Comes on when there is a problem with the engine emissions control
system, or the fuel fill cap is missing, or loose.
• Blinks when ...