Starter Overhaul

Disassembly/Reassembly Armature Inspection and Test 1. Remove the starter (see page 4-11). 2. Disassemble the starter as shown in the Exploded View. 3. Inspect the armature for wear or dama ...

Component Location Index

...

See also:

Battery Removal and Installation
NOTE: The battery terminal disconnection and reconnection procedure (see page 22-91) must be done before and after doing this procedure- Some systems store data in memory that is lost when the batt ...

Synchro Sleeve and Hub Inspection and Reassembly
1. Inspect the gear teeth on all synchro hubs and synchro sleeves for wear (rounded off corners). 2. Install each synchro hub (A) in its mating synchro sleeve (B), and check for free movement. Ma ...

Secondary Shaft Idler Gear Removal and Installation
Special Tools Required Attachment 42 mm I.D. 07QAD-P0A0100 Removal Place a spacer (A) on the secondary shaft (B), and set a puller (C) under the idler gear (D), then remove the idler gear. Ins ...