Honda Accord: Ignition Switch Test
NOTE: SRS components are located in the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repairs or servicing.
1. Do the battery terminal disconnection procedure (see page 22-91).
2. Remove the steering column covers (see page 20-181).
3. Disconnect the 5P connector (A) from the ignition switch (B).
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the ignition switch (see page 22-107).
6. Do the battery terminal reconnection procedure (see page 22-91).
Park Pin Switch Test
Produced in USA models 1. Remove the center console (see page 20-158). 2. Disconnect the A/T gear position indicator panel light/park pin switch 6P connector (A) from the park pin switch (B). ...Ignition Switch Replacement
NOTE: SRS components are located In the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repai ...See also:
Additional Safety Precautions
Never hold an infant or child on
your lap. If you are not wearing a
seat belt in a crash, you could be
thrown forward and crush the
child against the dashboard or a
seat-back. If you are wea ...
Rocker Arm Oil Control Valve
Removal/Installation
All models except PZEV
1. Remove the strut brace (see page 20-306).
2. Disconnect the rocker arm oil control solenoid
connector (A) and the rocker arm oil pressure switch
connector (B).
3. Re ...
PCV Valve Replacement
1. Disconnect the PCV hose.
2. Remove the PCV valve (A).
3. Install the parts in the reverse order of removal with a
new washer (B). ...