ENGINE START/STOP Button

• Changing the Power Mode ENGINE START/STOP Button Operating Range You can start the engine when the smart entry remote is inside the vehicle. The engine may also run if the smart entry r ...

Turn Signals

The turn signals can be used when the ignition switch is in ON . • One-touch turn signal When you lightly push up or down and release the turn signal lever, the exterior turn signals and t ...

See also:

Backlash Inspection
1. Install both axles into the A/T differential, then place the axles on V-blocks. 2. Check the backlash of the pinion gears (A) using a dial indicator (B). Standard: 0.05-0.15 mm (0.002-0.006 i ...

Alternator FR Signal Circuit Troubleshooting
1. Start the engine, and let it idle. 2. Monitor the ALTERNATOR in the DATA LIST with the HDS. 3. Check if the indicated percentage varies when the headlight switch is turned on. Does the p ...

Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions, and procedures (see page 24-25) before doing rep ...