Honda Accord: Ignition Coil and Spark Plug
Removal/Installation - Ignition System - Engine Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Ignition Coil and Spark Plug Removal/Installation

1. Remove the ignition coil cover (A).

2. Disconnect the ignition coil connectors (B), then


2. Disconnect the ignition coil connectors (B), then remove the ignition coils (C).

3. Remove the spark plug and inspect them (see page 4-20).

4. Apply a small amount of anti-seize compound to the plugs into the cylinder head, finger tight. Toque them to18N-m(1.8 kgf-m, 13 Ibfft).

5. Install the ignition coils, then connect the ignition coil connectors.

6. Install the ignition coil cover.

    Ignition Timing Inspection
    1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

    Spark Plug Inspection
    1. Remove the ignition coils (see page 4-20). 2. Remove the spark plugs, then inspect the electrodes and the ceramic insulator. - Burned or worn electrodes may be caused by these conditions: ...

    See also:

    Symptom Troubleshooting Index
    ...

    Brake Booster Test
    Functional Test 1. With the ignition switch in LOCK (0), press the brake pedal several times to deplete the vacuum reservoir, then press the brake pedal hard and hold it for 15 seconds. If the bra ...

    Tire Pressure Sensor Replacement
    Removal Each tire pressure sensor contains a lithium anode battery that is not removable. The complete tire pressure sensor should be disposed of according to local battery disposal guidelines o ...