Honda Accord: Idler Gear Shaft Bearing Replacement
Special Tools Required
-Adjustable Bearing Puller, 25—40 mm 07736-A01000B
•Driver Handle, 15 x 135L 07749-0010000
-Attachment, 52 x 55 mm 07746-0010400
1. Remove the idler gear shaft bearing (A) from the end cover (B) using the 25—40 mm adjustable bearing puller and a commercially available 3/8 "-16 slide hammer (C).
2. Install a new bearing in the end cover using the driver handle and the 52 x 55 mm attachment.
Park Lever Stop Inspection and Adjustment
1. Set the park lever in the P position. 2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard: 57.7-58.7 mm (2.27-2.31 in) 3. If the measurem ...Selector Control Shaft Oil Seal Replacement
Special Tools Required -Driver Handle, 15 x 135L 07749-0010000 •Attachment 22 x 24 mm 07746-001A800 1. Remove the oil seal (A) from the end cover (B). 2. Install a new oil seal flush to the ...See also:
Transmission Number
Transmission Type
88E5: 5-speed Manual
M91 A: 5-speed Automatic
B90A: 5-speed Automatic
Serial Number
3000001-”. M91A, B90A
8400001-: 88E5 ...
DTC Troubleshooting
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
1. ...
Song By VoiceTM (SBV)
Use SBV to search for and play music from your HDD or iPod® using voice
commands.
• To enable SBV
1. Press the SETTINGS button.
2. Rotate to select System
Settings, then
press .
3. R ...