Honda Accord: Idle Control System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Fuel and Emissions / Idle Control System
- Component Location Index
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- Alternator FR Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
- Idle Speed Inspection
- ECM/PCM Idle Learn Procedure
Rocker Arm Oil Pressure Switch B
Removal/Installation
PZEV model
1. Remove the rocker arm oil control valve (see page
11-275).
2. Remove rocker arm oil pressure switch B.
3. Install the parts in the reverse order of removal with a
new O-ring (A) ...
See also:
Ignition Switch
WARNING
Removing the key from the ignition switch
while driving locks the steering. This can
cause you to lose control of the vehicle.
Remove the key from the ignition switch
only when p ...
Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed.
1. Measure the cylinder bores (see page 7-17).
If the engine block is to be reused, hone the cylinders,
and remeasure the bores.
2. Re ...
Circuit Diagram
DRIVER'S UNDER-DASH FUSE/RELAY
BOX CONNECTOR P (20P)
BRAKE PEDAL POSITION
SWITCH 4P CONNECTOR
GAUGE CONTROL MODULE 32P CONNECTOR
VSA OFF SWITCH
BP CONNECTOR
YAW RATE-LATERAL
ACCELE ...
