Gearbox Mount Cushion Replacement

1. Remove the steering gearbox (see page 17-37). 2. Position a 40 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 150 mm flange bolt (C), and a 10 mm nut (D) as ...

Component Location Index

...

See also:

Front Grille Cover Replacement
2-door NOTE: - Take care not to scratch the front grille or the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Remove the front grille cov ...

Connecting Rod Bolt Inspection
1. Measure the diameter of each connecting rod bolt at point A and point B. 2. Calculate the difference in diameter between point A and point B. Point A-”Point B = Difference in Diameter D ...

Secondary Shaft 2nd Gear Axial Clearance Inspection
1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...