Honda Accord: How to Use HFL
The ignition switch must be in the ACCESSORY (I) or ON (II) position.
To use HFL, you need to pair your Bluetooth-compatible cell phone to the system.
Information Display
When there is an incoming call, or
HFL is in use, ‘‘HANDSFREELINK’’
will appear on the display.
‘‘ ’’ indicator will be
displayed on
the audio display when a phone is
lin ...
Phone Setup
This command group is available for
paired cell phones.
Phone pairing tips
You cannot pair your phone while
the vehicle is moving.
Your phone must be in discovery
or search mode to pair. Refe ...
See also:
Washer Reservoir Replacement
1. Remove the right inner fender (see page 20-290).
2. Disconnect the 2P connector(s) (A) from the washer
motor (B) and the washer fluid level switch (Canada
models).
Washer Reservoir Capacity:
...
Engine Coolant Check
Look at the coolant level in the
radiator reserve tank. Make sure it is
between the MAX and MIN lines. If
it is below the MIN line, see Adding
Engine Coolant for information on adding ...
Symptom Troubleshooting
VSA activation indicator does not go off, and
no DTCs are stored
NOTE: If the VSA modulator was replaced prior to the
activation indicator turning on, do the VSA sensor
neutral position memorizati ...