Honda Accord: How the SRS Indicator Works - Additional Information About Your Airbags - Driver and Passenger Safety - Honda Accord 2008-2012 Owner's ManualHonda Accord: How the SRS Indicator Works

The SRS indicator alerts you to a

The SRS indicator alerts you to a potential problem with your airbag system components.

When you turn the ignition switch to the ON (II) position, this indicator comes on briefly then goes off. This tells you the system is working properly.

If the indicator comes on at any other time, or does not come on at all, you should have the system checked by your dealer. For example:

If the SRS indicator does not come on after you turn the ignition switch to the ON (II) position.

If the indicator stays on after the engine starts.

If the indicator comes on or flashes on and off while you drive.

If you see any of these indications, the airbag system components may not work properly when you need them.

Ignoring the SRS indicator can

Ignoring the SRS indicator can result in serious injury or death if the airbag systems or tensioners do not work properly.

Have your vehicle checked by a dealer as soon as possible if the SRS indicator alerts you to a possible problem.

    How Your Side Curtain Airbags Work
    In a moderate to severe side impact, sensors will detect rapid acceleration and signal the control unit to instantly inflate the side curtain airbag. If the impact is on the passenger’s ...

    How the Side Airbag Off Indicator Works
    This indicator alerts you that the passenger’s side airbag has been automatically shut off. It does not mean there is a problem with your side airbags. When you turn the ignition switch t ...

    See also:

    Wheel Runout Inspection
    1. Raise and support the vehicle (see page 1 -13). 2. Check for a bent or deformed wheel. 3. Set up the dial gauge as shown, and measure the axial runout by turning the wheel. Front and rear w ...

    Audio with Touch Screen
    Use the touch screen to operate the audio system. • Selecting an Audio Source Select Source, then select an icon on the source list to switch the audio source. • Displaying the Menu Items ...

    Door Lock Knob Switch Test
    Driver's Door 1. Remove the driver's door panel (see page 20-17). 2. Disconnect the 10P connector (A) from the door lock actuator (B). 3. Check for continuity between the terminals. • ...