Honda Accord: Horn Test/Replacement
1. Remove the grille cover;
•2-door (see page 20-274)
• 4-door (see page 20-274)
2. Disconnect the 1P connector (A) from each horn (B).
3. Test the horn by momentarily connecting L _.tte.\ power to the terminal (A) and grounding the bracket (B). The horn should sound.
4. If it fails to sound, replace it.
Circuit Diagram
...
Horn Switch Test
NOTE: Check for a blown No. 10 (20 A) fuse in the
under-hood fuse/relay box. If it is blown, check for a
faulty horn relay.
1. Turn the steering wheel 180 degrees from the center
position and re ...
See also:
Carrier Bearing Replacement
Special Tools Required
Attachment, 40 x 50 mm 07LAD-PW50601
NOTE:
-The bearing and the bearing outer race should be
replaced as a set.
-Inspect and adjust the carrier bearing
preload
wheneve ...
Body Electrical
Special Tools
General Troubleshooting Information
Tips and Precautions
Special Tools Required
Back Probe Adapter, 17 mm 07TAZ-001020A
1. Check applicable fuses in the appropriate fuse/relay
...
B-CAN System Diagnosis Test Mode
B
Do this diagnosis if any of the control units are not
communicating (Not Available is displayed in the HDS)
as found by the B-CAN System Diagnosis Test Mode A
(see page 22-134).
1. Using the HDS ...