Honda Accord: Hood Release Handle Replacement
NOTE: - Put on gloves to protect your hands.
- Take care not to scratch the body.
-Take care not to kink the hood opener cable.
1. Remove the driver's kick panel: - 2-door (see page 20-105) - 4-door (see page 20-107) 2. Remove the bolts, then remove the hood release handle (A).
3. Disconnect the hood opener cable (B) from the hood release handle.
4. Install the hood release handle in the reverse order of removal, and note these items: - Make sure the hood opener cable is connected properly.
- Make sure the hood opens properly.
Hood Latch Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the body or the related parts.
1. Remove the front grille cover:
- 2-door (see page 20-274)
- 4-door (see page 20-274)
...
Trunk Lid Opener/Fuel Fill Door Opener
Replacement
Special Toots Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Take care not t ...
See also:
ELD Replacement
1. Do the battery terminal disconnection procedure (see
page 22-91).
2. Remove the upper cover (A), then remove the two
positive ( + ) terminals (B).
3. Remove the under-hood fuse/relay box (C ...
Clutch (cont'd)
...
Front Passenger's Weight Sensor Output Check After
a Vehicle Collision
1. Position the front passenger's seat to the rear most
position, and adjust the seat-back to the forward most
position. Do not move the seat from this position.
2. Drive the vehicle, accelerate ...