Honda Accord: Hood Opener Cable Replacement
NOTE: - Put on gloves to protect your hands.
- Take care not to scratch the body or the related parts.
- Take care not to kink the hood opener cable.
1. Remove these items: - Front grille cover: - 2-door (see page 20-274) - 4-door (see page 20-274) - Front fender trim, left side: - 2-door (see page 20-277) - 4-door (see page 20-277) - Front inner fender, left side as needed (see page 20-290) - Kick panel, driver's side: - 2-door (see page 20-105) - 4-door (see page 20-107) 2. Disconnect the hood opener cable (A) from the hood latch (B) (see page 20-302).
3. Detach the clips with a clip remover.
4. Disconnect the hood opener cable (A) from the hood release handle (B) (see page 20-303).
5. Remove the grommet (C), then remove the hood opener cable.
6. Install the cable in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.
- When installing the opener cable under the dashboard, route the cable under the left engine compartment wire harness (D).
Trunk Lid Opener Cable/Fuel Fill Door Opener Cable Replacement
SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...See also:
Rocker Arm Assemblf Installation
1. Reassemble the rocker arm assembly (see page 6-82).
2. Clean and dry the No. 5 rocker shaft holder mating
surface.
3. Apply liquid gasket P/N 08717-0004, 08718-0003, or
08718-0009 to the cy ...
Hood Adjustment
1. Remove these Items:
- Front grille cover:
- 2-door (see page 20-274)
- 4-door (see page 20-274)
- Cowl covers (see page 20-278)
- Hood latch cover, 4-door (see step 2 on page 20-302)
2. Sligh ...
MICU Input Test
NOTE:
• Before testing, troubleshoot the multiplex
integrated control unit first, using B-CAN System Diagnosis Test Mode A
{see page 22-134).
• Before testing, make sure the No. 15 (7 ...