Honda Accord: High Mount Brake Light Replacement
1. Open the trunk lid.
2. Disconnect the 2P connector (A) from the high mount brake light.
High Mount Brake Light: 21 W
3. Turn the bulb socket (B) 45 В° counterclockwise to remove the bulb (C).
4. Remove the rear shelf (see page 20-128).
5. Remove the high mount brake light (A).
6. Install the light in the reverse order of removal.
License Plate Light Replacement
4-door
1. Poll the license plate light assembly out, and
disconnect the 2P connector (A) from the license plate
light.
License Plate Light: 5W
2. Separate the lens (B) and housing (C), then rem ...
Brake Pedal Position Switch Test
1. Disconnect the 4P connector (A) from the brake pedal
position switch (B).
2. Check for continuity between terminals No. 1 and No.
2.
• There should be continuity when the brake pedal ...
See also:
Specifications
• Vehicle Specifications
• Engine Specifications
• Fuel
• Battery
• Washer Fluid
• Light Bulbs
• Brake/Clutch Fluid
• Automatic Transmission (CVT) Fluid
• M ...
Voice Control Switch Test
1. Remove the voice control switch (see page 17-7).
2. Measure the resistance between terminals No. 2 and
No. 4 in each switch position according to the table.
3. If the resistance is not as sp ...
ATF Cooler Cleaning
Special Tools Required
•ATF Cooler Cleaner GHTTTCF6H
-Magnetic Nonbypass Spin-On Filter GTHGNBP2*
*: Available through the Honda Tool and Equipment
Program 888-424-6857.
Before installing an ...