Honda Accord: HFL System Troubleshooting
NOTE: • Before doing this troubleshooting, refer to General Troubleshooting Information (see page 23-254) to make sure the phone is compatible and configured correctly.
• You must be able to duplicate the customer's concern to successfully diagnose the problem.
• Always use the customer's phone.
• Make sure the phone is approved and configured correctly. Online, go to www.handsfreelink.honda.com, or call the HFL support desk at 888-528-7876.
1. Connect the HDS to the DLC.
2. Turn the ignition switch to ON (II).
3. Check for DTCs.
Are any DTCs indicated? YES
-Repair the indicated DTCs and recheck.
NO
-Go to step 4.
4. Try to duplicate the problem.
Can you duplicate the problem? YES-Go to step 5.
NO-The system is OK at this time.
5. Pair the phone to a known-good vehicle (same model, year, and trim), and try duplicate the problem.
Does the phone have the same problem on the known-good vehicle? YES
-Call the HFL support desk at 888-528-7876 to make sure the phone is configured correctly and has the correct software. Ifthe phone is configured correctly, it is either a characteristic of the HFL system, or a characteristic of the particular approved phone being used. Explain to your customer that this is a system characteristic. Another phone from the approved phone list may give more favorable results.
NO
-Substitute a known-good HandsFreeLink control unit and recheck. Ifthe problem goes away, replace the original HandsFreeLink control unit (see page 23-281 ).
System Description
HandsFreeLink Control Unit Inputs and Outputs
HandsFreeLink Control Unit 28P Connector
*l:The shielded wires have a heat-shrink tube insulating the outside of the
wire. The color of the insula ...
Circuit Diagram
...
See also:
DTC Troubleshooting Index
HandsFreeLink Control Unit
...
Crankshaft Pulley Removal and Installation
Special Tools Required
Handle, 6-25-660L 07JAB-001020B
Crankshaft Pulley Holder 07AAB-RJAA100
Socket, 19 mm 07JAA-001020A or equivalent
Removal
1 . Remove the front wheels.
2. Remove the splas ...
Intermediate Shaft Reassembly
Exploded View
Special Tools Required
-Oil Seal Driver 07GAD-PH70201
-Half Shaft Base 07NAF-SR30101
-Attachment 52 x 55 mm 07746-0010400
-Attachment 35 mm I.D. 07746-0030400
-Driver Handle, 15 ...