Honda Accord: HFL Switch Test
1. Remove the driver's airbag (see page 24-211) 2. Remove the steering wheel (see page 17-6).

3. Measure the resistance between terminals No. 3 and No. 4 in each switch position according to the table.
HFL-Voice Control Switch

4. If the resistance is not as specified, replace the switch (see page 17-7).
Symptom Troubleshooting
The HFL digits do not go away from the
audio-HVAC subdisplay or the audio HVAC
display after pressing the HFL BACK button
1. Connect the HDS to the DLC (see page 23-252).
2. Clear the DTCs with ...
Front HFL-ANC Microphone
Removal/Installation
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard and related
parts.
• Lay a workshop towel under the parts when working
on them to protect ...
See also:
Crankshaft Installation
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Attachment, 24 x 26 mm 07746-0010700
Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100
1. M/T model: Install the crankshaft end bushing ...
Fuse Locations
If any electrical devices are not working,
turn the ignition switch to LOCK
and
check to see if any applicable fuse is blown.
• Engine Compartment Fuse Box
Located near the brake fluid rese ...
Hard Disc Drive (HDD) Audio
If an error occurs while playing the Hard Disc Drive (HDD) Audio, you may see
the
following error messages. If you cannot clear the error message, contact a
dealer.
iPod®/USB Flash Drive
If ...