Honda Accord: Heating/Air Conditioning
- Component Location Index
- A/C Service Tips and Precautions
- A/C Refrigerant Oil Replacement
- A/C Line Replacement
- A/C System Inspection
- General Troubleshooting Information
- Symptom Troubleshooting Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Recirculation Control Motor Circuit Troubleshooting
- HVAC Control Power and Ground Circuit Troubleshooting
- A/C Condenser Fan Circuit Troubleshooting
- Radiator and A/C Condenser Fan Common Circuit Troubleshooting
- Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
- A/C Condenser Fan High Speed Circuit Troubleshooting
- A/C Compressor Clutch Circuit Troubleshooting
- A/C Pressure Switch Circuit Troubleshooting
- A/C Signal Circuit Troubleshooting
- Evaporator Temperature Sensor Test
- Power Transistor Test
- Air Mix Control Motor Test
- Air Mix Control Motor Replacement
- Mode Control Motor Test
- Mode Control Motor Replacement
- Recirculation Control Motor Test
- Recirculation Control Motor Replacement
- HVAC Control Unit Removal / Installation
- Blower Unit Removal/Installation
- Blower Unit Component Replacement
- Evaporator Core Replacement
- Expansion Valve Replacement
- Heater Unit/Core Replacement
- A/C Compressor Replacement
- A/C Compressor Clutch Check
- A/C Compressor Clutch Overhaul
- A/C Compressor Relief Valve Replacement
- A/C Condenser Replacemen
- Receiver/Dryer Desiccant Replacement
- Dust and Pollen Filter Replacement
- Refrigerant Recovery
- System Evacuation
- System Charging
- Refrigerant Leak Check
- A/C System Noise Check
- A/C System Test
Component Location Index
'10 model
...
See also:
Brake and Clutch Fluid
Check the fluid level in the
reservoirs monthly. There are up to
two reservoirs, depending on the
model. They are:
Brake fluid reservoir (all models)
Clutch fluid reservoir
(manual transmiss ...
Secondary Shaft Disassembly,
Inspection, and Reassembly
1. Inspect the thrust needle bearings a n d the needle bearings for g a l l i
n g and rough movement
2. Inspect the splines for excessive wear and damage.
3. Check the shaft bearing surface fo ...
Expansion Valve Replacement
1. Remove the evaporator core (see page 21-67).
2. Remove the insulator (A) and bolts, then remove the
expansion valve (B) and O-rings (C).
3. Install the expansion valve in the reverse order o ...
