Honda Accord: Headlight Replacement - Exterior Lights - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Headlight Replacement

4-door

1. Remove the parts shown.

• Upper fender trim (see page 20-277) • Front bumper (see page 20-255) • Front bumper absorber (see page 20-255) 2. Remove the three bolts, and pull the headlight (A) out slightly.

3. Remove the harness clip (B) from the headlight


3. Remove the harness clip (B) from the headlight housing, and disconnect the connectors (C) from the bulb sockets.

4. Remove the headlight with the corner upper beam (D).

NOTE: Be careful not to scratch the headlight lens and the fender.

5. Remove the two bolts (E) and the corner upper beam from the headlight 6. Install the headlight in the reverse order of removal.

7. After replacement, adjust the headlight (see page 22-233).

2-door

1. Remove the parts shown.

•Upper fender trim (see page 20-277) • Front bumper (see page 20-255) • Front bumper absorber (see page 20-255) 2. Remove the three bolts, and pull the headlight (A) out slightly.

3. Remove the harness clip (B) from the headlight


3. Remove the harness clip (B) from the headlight housing, and disconnect the connectors (C) from the bulb sockets.

4. Remove the headlight with the corner upper beam (D).

NOTE: Be careful not to scratch the headlight lens and the fender.

5. Remove the two bolts (E) and the corner upper beam from the headlight 6. Install the headlight in the reverse order of removal.

7. After replacement, adjust the headlight (see page 22-233).

    Headlight Adjustment
    Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off. Before adjusting the headlights: • Park the vehicle on a level ...

    Bulb Replacement
    Headlight (High'Beam) 1. Disconnect the 2P connector (A) from the headlight Headlight (High Beam): 60 W 2. Turn the bulb socket 45 В° counterclockwise to remove the bulb. 3. Install a new b ...

    See also:

    Operating the XM Radio
    To listen to XM Radio, turn the ignition switch to the ACCESSORY (I) or ON (II) position, and press the button. The last channel you listened to will show in the audio screen and the cent ...

    General Troubleshooting Information
    Mow to Check for DTCs with the HDS NOTE: Check the vehicle battery condition first {see page 22-90). 1. Make sure the ignition switch is turned to LOCK (0). 2. Connect the HDS to the data link ...

    Moonroof Switch Test/Replacement
    1. Remove the front Individual map lights (see page 22-258). 2. Disconnect the moonroof switch 12P connector (A) and map light 3P connector (B). 3. Remove the moonroof switch (C) from the map ...