Honda Accord: Headlight Adjustment - Exterior Lights - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Headlight Adjustment

Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.

Before adjusting the headlights: • Park the vehicle on a level surface.

• Make sure the tire pressures are correct.

• The driver or someone who weighs the same should sit in the driver's seat (or an equivalent amont of weight).

1. Clean the outer lens so that you can see the center (A) of the headlights.

2. Park the vehicle in front of a wall or a screen (A).


2. Park the vehicle in front of a wall or a screen (A).

3. Turn the low beams on.


3. Turn the low beams on.

4. Determine if the headlights are aimed properly.

Vertical adjustment: Measure the height of the headlights (A).

Adjust the upper edge of the cut line (B) to the headlights' height.

5. If necessary, open the hood and adjust the headlights


5. If necessary, open the hood and adjust the headlights by turning the vertical adjuster (A).

NOTE: The Ft and L adjusters are not applicable for USA models. The headlights can only be adjusted up and down.

4-door:


4-door:

2-door:


2-door:

Headlight Replacement


    Combination Light Switch Test/Replacement
    1. Remove the driver's dashboard lower cover (see page 20-166). 2. Remove the steering column covers (see page 17-10). 3. Disconnect the 12P connector (A) from the combination light switch (B). ...

    Headlight Replacement
    4-door 1. Remove the parts shown. • Upper fender trim (see page 20-277) • Front bumper (see page 20-255) • Front bumper absorber (see page 20-255) 2. Remove the three bolts, and ...

    See also:

    Power Window Master Switch Replacement
    4-door 1. Carefully remove the power window master switch (A). 2. Disconnect the 37P connector (B) from the power window master switch, and the 13P connector (C) from the power mirror switch (D ...

    Circuit Diagram
    ...

    Rear Air Outlet Replacement
    NOTE: Take care not to scratch the body. 1_ Remove the rear bumper (see page 20-260). 2. Release the hooks (A), then remove the rear air outlet (B). 3. Install the air outlet by pushing on t ...