Honda Accord: Hazard Warning Switch
Test/Replacement
1. Remove these items: • Center vent for w i t h navigation system (see page 20-178) • Audio unit for without navigation system (see page 23-115) 2. Remove the hazard warning switch (A).
3. Check for continuity between the terminals in each switch position according to the table.
NOTE: Make sure the correct test lead (+ or —) is placed on the terminal.
4. If the continuity is not as specified, replace the hazard warning switch.
MICU Input Test
NOTE:
• Before testing, troubleshoot the multiplex
integrated control unit first, using B-CAN System Diagnosis Test Mode A
(see page 22-134).
• Before testing, make sure the No. 5 (7. ...
Interior Lights
...
See also:
Cruise Control Combination
Switch Test/Replacement
SRS components are located in this area. Review the
SRS component locations:
2-door fsee page 24-23)
4-door (see page 24-21)
Precautions and procedures (see page 24-25), in the SRS
before d ...
A/C Condenser Fan High Speed Circuit
Troubleshooting
ECM/PCM CONNECTOR A (49P)
Terminal side of female terminals
Is there battery voltage?
YES-Go to step 6.
NO-Repair an open in the wire between the
under-hood fuse/relay box and the ECM/PCM. If ...
Parking Light Bulbs
When replacing, use the following bulbs.
Turn the steering wheel and pull the inner fender back in the same way as
when
replacing the front turn signal/side marker light bulbs.
1. Turn the s ...