Honda Accord: Grab Handle Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE: - Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Lower the grab handle (A), then insert a small flat-tip screwdriver into the notch.
2. Pull on the small flat-tip screwdriver with the appropriate trim tool (A), and remove the cap (B).
3. Pinch the clips (A) to release the hooks (B), then remove the grab handle (C).
4. Pinch the hooks on the clips (A) with a pair of pliers, and pull out the clips of the bracket.
5. If the side curtain airbag has deployed, replace the grab handle with a new one. (see page 24-208) 6. If the side curtain airbag has not deployed,inspect the grab handle for damage. A damaged grab handle may cause the side curtain airbags to deploy improperly, possibly causing injury. Replace the grab handle if it has any of the following damage: - Any cracks or damage in the grab handle (A).
- Any cracks or stress-whitening in the caps (B).
7. Install the clips (A) on the grab handle (B), then insert the caps (C) fully into the clips.
8. Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely
Sunvisor Removal/Installation
NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the headliner.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
1. ...
Headliner Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component ...
See also:
Secondary Shaft 1 st Gear Axial
Clearance Inspection
Special Tools Required
Attachment, 42 mm I.D. 07QAD-P0A0100
1. Remove the secondary shaft transmission housing
bearing (see page 14-270).
2. Install the thrust needle b e a r i n g (A), the need ...
Starter Performance Test
1. Remove the starter (see page 4-11).
2. Firmly clamp the starter in a vise.
3. Make a connection for this test using the thickest
(gauge) wire possible (preferably the same gauge as
used on ...
DTC Troubleshooting
DTC 81152: Gauge Control Module (EEPROM)
Error
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instructions in B-CAN System Diagnosis
Test Mode A (see page 22-134).
1. Cle ...