Honda Accord: Glove Box Striker Replacement - Dashboard - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Glove Box Striker Replacement

SRS components are located in this area. Review the SRS component locations, 2-door {see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repairs or service.

NOTE: Take care not to scratch the dashboard or the related parts.

1. Disconnect the glove box damper from the pivot on the glove box (see step 2 on page 20-174).

2. While holding the glove box, release the glove box stop on each side from the dashboard by pushing them inside (see step 5 on page 20-175).

3. Remove the screws, then remove the glove box striker (A).

4. Install the striker in the reverse order of removal.


4. Install the striker in the reverse order of removal.

    Glove Box Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component l ...

    Dashboard Side Vent Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* * Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE; - Take care not to scratch the dashboard or the related p ...

    See also:

    Using the Paddle Shifters in the D position (D-Paddle Shift Mode)
    V6 models only When you are driving in theD position, you can shift the transmission up or down manually with the paddle shifters. To shift up or down, use the + (right) or - (left) paddl ...

    Front Individual Map Light Test/Replacement
    With moonroof 1. Turn the map light switch OFF. 2. Carefully pry the lens ( A ) off with a small screwdriver. Individual Map Light: 8 W x 2 3 . Remove the screws, then remove the individual ma ...

    Fuel Tank Draining
    1. Remove the fuel tank unit (see page 11 -320). 2. Using a hand pump, a hose, and a container suitable for fuel, draw the fuel from the fuel tank. 3. Reinstall the fuel tank unit (see page 11- ...