Honda Accord: Glass Position Adjustment - Moonroof - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Glass Position Adjustment

The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/— 1 mm (0+0.04/—0.04 in) all the way around. If not make the following adjustment:

1. Remove the bracket cover (see step 3 on page 20-91).


1. Remove the bracket cover (see step 3 on page 20-91).

2. Adjust the glass (A).

-1. Slightly loosen the TORX bolts with a TORX T25 bit.

-2. Move the glass up or down.

-3. Tighten all bolts securely.

3. If necessary, repeat on the opposite side.


3. If necessary, repeat on the opposite side.

4. Reset the moonroof control unit (see page 22-371).

    Symptom Troubleshooting Index
    ...

    Glass Replacement
    1. Close the glass fully. 2. Slide the sunshade all the way back. 3. Pry out the lid (A), remove the screw (B), and release the hooks (C), then remove the bracket cover (D). Repeat on the op ...

    See also:

    Intermediate Shaft Reassembly
    Exploded View Special Tools Required -Oil Seal Driver 07GAD-PH70201 -Half Shaft Base 07NAF-SR30101 -Attachment 52 x 55 mm 07746-0010400 -Attachment 35 mm I.D. 07746-0030400 -Driver Handle, 15 ...

    ECM/PCM Update
    Special Tools Required  - Honda diagnostic system (HDS) tablet tester  - Honda Interface Module (HIM) and an iN workstation with the latest HDS software version  - HDS pocket tester ...

    Cam Chain Case Oil Seal Installatio
    Special Tools Required Driver Handle, 15 x 135L 07749-0010000 Attachment, 52 x 55 mm 07746-0010400 1. Clean and dry the crankshaft oil seal. 2. Apply a light coat of new engine oil to the lip of ...